Mama Bear Keychain | Add-On Cub Sublimation Blanks

Mama Bear Keychain with add-on cubs for sublimation heat press 

BLANKS FOR SUBLIMATION

The Cubs are purchased individually. The Mama Bear with add-on Cub Keychain is approximately 1/8” thick.  Each Mama Bear is appx 3.75"X2.25". Each cub is appx 1.75"X1.07".  The split key ring is 1.38". The jump ring with chain is appx 1".

PRESSING INSTRUCTIONS:

1. Remove the clear or blue film from the substrate.
2. Remove residue, if any, with a soft damp cloth
3. Place your transfer face down and MDF substrate face up. Secure with heat tape
4. Press for 50-55 seconds @ 380 degrees medium pressure. (Time and temp may vary based on your heat press)

Blank Sublimation Unisub, Hardboard, MDF,  Ready to Sublimate